Trim Audio
Cut a chosen time range from an audio file, or remove the middle and keep both ends — no timeline editor needed.
Your file stays in this tab. Decoding and encoding run in a background worker on your device.
Drop your file here
MP4, MOV, WebM, MKV or M4V.
You can also paste a file from the clipboard.
How to use it
- Drop an audio file.
- Enter a start time and an end time, or leave end at zero.
- Choose Keep or Remove.
- Press start and download the trimmed file.
About this tool
Trimming is the most common audio edit: drop the ten seconds of silence at the start, cut a tangent from the middle of a voice memo, or pick the chorus out of a longer recording. This tool asks for two timestamps and does the rest, without loading a waveform editor or installing anything.
The Keep mode exports only the range between start and end. The Remove mode deletes that range and joins what remains, which is useful for taking out a mistake, an interruption or a section that should not be published. A zero end means “until the end of the file”, so trimming the beginning needs only a start value.
Cuts are made on decoded samples, not on guessed byte offsets, so the result is frame-accurate at the source sample rate. If the cut falls between samples it is rounded to the nearest one — a difference far below what anyone can hear. The output is re-encoded, which is why the tool warns that a lossy source loses a little quality again.
Timestamps are in seconds and accept decimals, so 12.5 starts at twelve and a half seconds. The tool validates the range before spending time on encoding: an end before the start, a start past the file duration, or a removal that would empty the file all stop with a clear message. Nothing is uploaded, and the original file is untouched.
Frequently asked questions
How accurate is the cut?
To the sample. Times are converted to frames at the file’s sample rate, so a cut at 3.5 seconds lands within one sample of the requested point.
Can I remove several sections at once?
One range per run. Remove the longest unwanted section first, download the result, then run the tool again on the new file for the next cut.
Does trimming re-encode the audio?
Yes. The output is encoded fresh, so MP3 sources go through one more lossy generation. Use WAV output if you are preparing a master for further editing.
What happens if I enter an end time longer than the file?
It is clamped to the file’s duration, so nothing breaks. A start time past the end is rejected, because there would be nothing to export.