Skip to main content

Change Audio Volume

Raise or lower the volume of an audio file by an exact number of decibels, with clipping warnings and a peak readout.

Your file stays in this tab. Decoding and encoding run in a background worker on your device.

Drop your file here

MP4, MOV, WebM, MKV or M4V.

You can also paste a file from the clipboard.

Options

How to use it

  1. Drop an audio file.
  2. Enter a gain in dB (for example 6 or -3).
  3. Press start.
  4. Download the adjusted file.

About this tool

Volume is measured in decibels. A doubling of perceived loudness is roughly +10 dB, a comfortable boost for quiet speech is +6 dB, and −6 dB halves it. This tool applies exactly the change you type, sample by sample, instead of guessing with a normalizer.

Boosting can push quiet material past full scale, where digital audio has no room left. The tool clamps those peaks and tells you if any were clipped, and it reports the final peak level so you can judge the result. If you only want the loudest possible clean file, Normalize Audio is the better tool.

The change applies to the whole file and preserves the balance between loud and quiet passages. Choose MP3 for sharing or WAV for a lossless hand-off; everything runs locally in a worker.

Frequently asked questions

Why does +6 dB sometimes not feel twice as loud?

Loudness perception depends on the material. If the source is already near full scale, the tool clips the peaks and the perceived increase is small.

What happens when peaks clip?

They are clamped at full scale to avoid harsh digital distortion, and the warning tells you it happened. Lower the gain or normalize instead.

Can I lower the volume below -60 dB?

The control stops at -60 dB, which is effectively silence. Going further is rarely useful.

Related tools